Benro MoveOver8B Carbon Fiber Slider with Case (127781)
- Includes SuperUser Group Membership
- 0.6m of Slider Carriage Travel
- Carriage Features 3/8"-16 Mounting Stud
- Smooth, Quiet Ball Bearing Slides
- Friction-Adjusting Knob and Brake
- 18mm Carbon Fiber Rails
- Supports over 17 Pounds
- Multi-Adjustable All-Terrain Legs
- Micro-Adjust Non-Scratch Feet
- 0 to 90° and Underslung Operation
This Benro MoveOver8B Carbon Fiber Slider with Case includes an aluminum slider carriage that runs on carbon fiber rails with 23.6" of actual carriage travel, and a soft carry case. The carriage features a flat mounting surface with a 3/8"-16 threaded mounting stud for mounting your flat base fluid head, and it features pre-tensioned roller bearings for a smooth glide. A built-in friction brake is controlled by a single knob, allowing you to adjust the friction on the slider, or even use it as a brake when the slider is level.
The slider features 18mm diameter carbon fiber rails and supports a total payload of up to 17.6 pounds. The slider can be mounted on a tripod or stands, or placed on a level surface. The built-in bubble level enables you to confirm that your slider is level. Each leg mounts onto the slider track ends via a rosette and can rotate throughout 360°, and each foot has approximately 4" of height adjustment for leveling. You can operate the slider on any angle from 0 to 90°, and you can even undersling the slider.
- The adjustable legs can be moved throughout 360° of rotation. However, they are at their most supportive between 12 and 60°.
- The track ends allow you to mount the slider on stands using the Baby pin slot. Each track end features 1/4"-20 and 3/8"-16 threaded mounting holes.
- The slider can also be mounted directly onto a tripod using the 3/8"-16 or 1/4"-20 threaded mounting hole on the attached cheese plate.
- The carriage has four 1/4"-20 threaded mounting holes for accessories.
- MPN - C08D6B
- GTIN - N/A
No available accessories for this Product
Specification
Actual Slider Carriage Travel: | 0.6 m |
Camera Mounting Screw: | 3/8"-16 Male |
Accessory Mounting: | 4 x 1/4"-20 Female Thread (Carriage) 3 x 1/4"-20 Female Thread (Rails) 1 x 3/8"-16 Female Thread (Rails) Two 1/4"-20 and one 3/8"16 accessory mounting threads on the top of each of the track ends, one 1/4"-20 on the underside |
Tripod Mounting: | 2 x 3/8"-16 Female Thread 1 x 1/4"-20 Female Thread |
Stand Receiver: | 2 x 5/8" |
Rail Diameter: | 18 mm |
Rail Material: | Carbon Fiber |
Quick Release Plate Type: | No Quick Release |
Carriage Dimensions: | 166.0 x 119.0 x 13.0 mm |
Body Material: | Aluminum |
Load Capacity: | 7.71 kg |
Track Width: | 100 mm |
Bubble level: | Yes |
Benro MoveOver8B Carbon Fiber Slider with Case